Skip to content
Audio One San Diego

Serving Point Loma

Amplifier Installation in Point Loma

Mono, 4-channel, and full-range amps installed and tuned. For Point Loma drivers, a 20 min drive to our shop on Palm Avenue.

From Point Loma
20 min
ZIP
92106, 92107
Open
7 days
Amplifier Installation for Point Loma drivers at Audio One San Diego

Amplifier Installation for Point Loma

What's included.

An amplifier is what makes aftermarket speakers actually breathe. Stock head-unit amplifiers typically deliver around 18 watts RMS per channel, enough for daily-driver volume, but well below what good aftermarket components are designed to receive. Our techs install mono subwoofer amplifiers, 4-channel speaker amps, 5-channel hybrids that drive front speakers and a sub from one chassis, and dedicated DSP-controlled amplifiers for builds where signal processing matters. Every install includes correct-gauge power wire (0/4/8 AWG depending on amp draw) routed cleanly through the firewall, an in-line fuse holder within 18 inches of the battery for safety, ground-loop isolators on factory radios to kill alternator whine, RCA shielding to prevent ignition noise, and final gain-matching using calibration tones and a multimeter. Gains are set with the speakers' RMS rating in mind so the amp runs in its clean range and the system has real headroom. Class-D efficient mono amps start around 500 watts RMS for daily-driver bass; 4-channel amps for full-range speaker upgrades start around 75 watts per channel. Lifetime workmanship warranty on every amp install.

  • 0/4/8 AWG power wire to spec
  • In-line fuse holder within 18" of battery
  • Ground-loop isolators on factory radios
  • Gain-matching with calibration tones

Point Loma

Why Point Loma drivers come to Audio One San Diego.

Point Loma drivers, a 20-minute drive up the I-5 to our Palm Avenue shop. Marine, Jeep, and daily-driver work all handled.

Point Loma blends Navy housing, Sunset Cliffs daily drivers, and a heavy boat-owning crowd around Shelter Island and Harbor Island marinas. The I-5 south from Rosecrans gets you to our shop in about 20 minutes. Common Point Loma work includes marine audio installs with UV-rated speakers and corrosion-resistant amps for boats kept in salt water year round, Jeep audio packages for Wranglers and Gladiators that double as beach rigs, factory-look CarPlay retrofits for daily-driver sedans, alarm systems for vehicles parked along the cliffs, and full system rebuilds for trucks heading to Liberty Station events. We also handle audio repairs on systems installed elsewhere, blown speakers, alternator whine, intermittent power loss. Walk in any day, financing through five lender partners, written quotes on the spot.

Local landmarks

Cabrillo National MonumentShelter IslandLiberty StationSunset Cliffs

Visit the shop

  • 1610 Palm Ave
    San Diego, CA 92154
  • Mon–Sat 9 AM – 7 PM
    Sun 9 AM – 5 PM
  • (619) 500-5560
Get a free quote

Point Loma to our shop

A short drive on Palm Ave.

FAQ

Amplifier Installation questions, Point Loma drivers

It's almost always a ground-loop or grounding issue. We use isolators and clean grounds during install, that's the fix.

Match RMS power to your speakers' RMS rating, with a little headroom. We'll size it correctly during quote.

Properly sized to your alternator output, no. On high-power builds we recommend a Big-3 wiring upgrade, which we install along with the amp.

Ready when you are

Get a quote for amplifier installation in Point Loma.

Walk in any day or call (619) 500-5560, 20 min from your front door.

DirectionsCall now